Blu-bathworks SA3006 User Manual download pdf (Page 3)

1 866 907 0122 blubathworks.com

2013-07

Installation Notes

Important! Install this product according to the installation guide. Product does have an overﬂow. Spout must provide a

minimum of 5” reach for adequate clearance into basin. Our products must be installed by certiﬁed professionals only

and according to our installation guide as well as federal, provincial / state and local building codes and regulations.

Installation Preparation

– Provide proper reinforcement, such as a brace, between the studs of the wall to help support the lavatory.

– Install the brace at the proper height, which corresponds to the bracket and lavatory mounting hole locations.

– Brace material must be of a material that cannot be crushed during installation of fasteners.

– For best results, the ﬂoor must be level and the wall must be square with the ﬂoor.

Installation for Wall-Hung Basins

LAVATORY INSTALLATION

1. Refer to the ﬁxture and measure mounting hole location for accuracy.

2. Use a pencil to mark the location of the ﬁxture mounting holes onto the mounting wall.

3. Measure and install recommended blocking to support vertical load. Ensure blocking member is secured into blocking

or solid wall structure. (Refer to diagram 2 for location.)

4. Lift and place the lavatory on to the wall and brace adequately so that the lavatory can not tip over.

Stud

Reinforcement brace – to width or greater of basin

Existing Wall

Recommend ½"- ¾" plywood

sheathing behind basin

Bowl

Recommended blocking

to support vertical load

+/- 2"- 4"

1 2 3 4 5

No comments

Blu-bathworks SA3006 User Manual Page 3